Perlick Beverage Dispenser Z2151 User Manual

Troubleshooting  
OPERATING INSTRUCTIONS  
SMART COUPLER with Empty Keg Sensor  
Problem:  
Beer flow is slower with Smart Coupler  
than with standard Perlick coupler.  
Part No.  
27500F  
Probable Cause: Beer Flow Control Handle is in CLEAN position.  
Solution:  
Slowly turn Beer Flow Control Handle to ON position.  
Problem:  
Beer does not flow after keg is tapped.  
The Smart Coupler* combines a  
standard Perlick single-valve keg  
coupler with a specially-designed  
keg sensor that eliminates the  
line loss that normally follows  
every empty keg. Fresh kegs can  
be drawn off immediately. The  
beer lines are always full of beer.  
Probable Cause: Smart Coupler has locked up.  
Solution: First, turn Beer Flow Control Handle to OFF position then  
turn Beer Flow Control Handle to CLEAN position. Wait  
five seconds then turn Beer Flow Control Handle to  
ON position.  
Probable Cause: Beer Flow Control Handle is OFF.  
Solution: Turn Beer Flow Control Handle to CLEAN position.  
Saves time  
Reduces beer waste  
Increases beer profits  
Wait five seconds then turn Beer Flow Control Handle to  
ON position.  
No. 27500F  
Smart Coupler with Empty Keg Sensor  
Reduces aggravation  
Probable Cause: Probe or Smart Coupler is dirty.  
Solution: Clean Smart Coupler.  
IMPORTANT!  
To ensure your complete satisfaction,  
please read these instructions before using Perlick’s Smart Coupler.  
Probable Cause: Out of gas.  
Solution:  
Reestablish gas flow.  
Retrofitting Single Valve Couplers  
Problem:  
Excessive foam.  
Perlick single valve keg couplers can be  
retrofitted to function as Smart Couplers.  
Simply replace the probe with Perlick’s  
No. 40119 empty keg sensor.  
Probable Cause: Beer temperature too high. Excessive beer flow rate. Beer  
is over-carbonated  
Solution:  
These problems are not caused by the Smart Coupler.  
Follow established procedures to correct the problem.  
1. Remove probe washer from  
bottom of probe.  
2. Remove retaining screw and  
yoke assembly.  
3. Lift probe out of body.  
4. Install Perlick’s empty keg sensor.  
When replacing probe washer  
make sure the “V”-groove surface  
faces “down”.  
Perlick’s Empty Keg Sensor  
No. 40119  
(Probe Washer Not Included)  
8300 West Good Hope Road • Milwaukee, WI 53223 • Phone 414-353-7060  
Fax 414-353-7069Toll Free 800-558-5592 • E-Mail: [email protected] • www.Perlick.com  
Form Z2151  
04.06.04  
* U.S. Patent #5,630,411  
 

PB Heat Boiler MI User Manual
Peavey DJ Equipment 4B User Manual
Philips Computer Monitor 107T60 User Manual
Philips CRT Television 14PT3685 User Manual
Philips Speaker 32HF9385D User Manual
Philips Surge Protector SPP4031A User Manual
Philips Telephone MAGIC5 User Manual
Pioneer DVD Recorder AVH P7500DVD User Manual
Polaris Offroad Vehicle 400 4X4 User Manual
Polk Audio Car Speaker PSW650 User Manual