PYLE Audio Stereo System PLVWAN6 User Guide

Parts Supplicd:  
Proper Location  
Powered Diversity TVAntenna  
1. TVAntenna(2)  
Mount the antenna on the inside rear window of the car.  
2. Power Cord Holder(6)  
3. Antenna Cable Holder(4)  
4. Seal(2)  
For optimum reception, mount the antenna pointing  
down.(See Fig 2)  
Leave a minimum of 1 inch space between the antenna  
wires and the edge of the window.  
Antenna  
Loading coil  
Location should not impair driver s view.  
Do not mount near or next to an existing antenna.  
Be certain that there is enough cable to reach the unit.  
Antenna cable  
Antenna plug  
PLVWAN6  
Trial fit the antenna-do not remove protective paper from  
booster or antenna sections.  
Installation Manual  
Booster amp section  
Power cord  
Mini jack  
Cigarette light plug  
(Fig 1)  
Y cable  
Note:  
1. Use only on vehicles with 12-14.4Volt battery  
2. Avoid short circuits by disconnecting the negative(-)battery  
cable before beginning installation.  
3. Protect the wiring by wrapping adhesive tape around  
exposed areas.  
4. Antenna wires should not come in contact with moving  
parts, areas of heat or sharp surfaces.  
5. Avoid installing in areas that may become wet with rain.  
Failure to do so may result in fire or electrical shock.  
(Fig 2)  
 

RCA Speaker System PRO CS5II User Guide
RCA TV Antenna ANT301F User Guide
Roland Music Mixer 04672434 User Guide
Roper Range W10017690 User Guide
Royal Sovereign Laminator ES 410 User Guide
Russell Hobbs Microwave Oven RHM2031 User Guide
Ryobi Trimmer 130rEB User Guide
Saeco Coffee Makers Espresso Maker Odea Giro User Guide
Samsung Heat Pump RC090MHXEA User Guide
Schumacher Battery Charger SE 1252MA User Guide