PYLE Audio TV Mount PSWLE59 User Guide

INSTALLATION GUIDE  
Item No.:PSWLE59  
Thank you for choosing our product  
Pyle Audio  
1600 63rd st , Brooklyn, NY, 11204  
(718)236-8000  
TV Size Range: 32"~55"  
Maximum Weight Capacity: 30kg/66lbs  
Locking by locking bar on the bottom  
Warning  
This product contains small items that could be a choking hazard if swallowed. Keep  
these items away from young children!  
1.Make sure these instructions are read and completely understood before attempting  
installation. If you are unsure of any part of this installation, contact a professional  
installer for assistance.  
www.pyleaudio.com  
CAUTION  
2.The wall or mounting surface must be capable of supporting the combined weight of  
the mount and the display; otherwise the structure must be reinforced.  
3.Safety gear and proper tools must be used. A minimum of two people are required  
for this installation. Failure to use safety gear can result in property damage, serious  
injury or death.  
This product was designed to be installed on wood stud walls and solid concrete walls.  
Before installing make sure the supporting surface will support the combined load of the  
equipment and hardware. Never exceed the Maximum Load Capacity. This product is  
intended for indoor use only. Use of this product outdoors could lead to product failure or  
personal injury.  
-8-  
 
Part 3-Mounting the flat ppaanneell ssccrreeeenn  
Part 1aa-Wood SStud Moouunting  
2,3  
Hook the top of brackets(2,3) onto the top flange  
of wall plate(1). Then swing the screen down.  
Use wall plate(1) as a template, make sure it is level, and mark four mounting  
holes along the center lines of the wood studs. Drill four 3/16(5mm)dia.  
holes 2(50mm) deep. Level wall plate(1) and attach to wall with four long  
bolts(G) and four washers(I). Tighten screws firmly. Do not overtighten.  
NOTE: Always use an assistant or mechanical  
lifting equipment to safely lift and position  
heavy equipment.  
1
Use the Locking bar(4) to prevent the TV from being removed or  
accidentally knocked off of the wall plate.When the locking bar half  
insertes into the wall plate , you can use the rotating rod(5) to make it  
fully inserted.  
5
4
Stud finder  
Wood stud  
I
2(50mm)  
G
Φ3/16(5mm)  
-3-  
-6-  
 
Part 2aa-Attaacching Brracketts To Scrreen Wiith Flaat Back  
Part 1b--Concrette Wall MMoounting  
Center brackets vertically on back of screen. Select the small(A or B),  
medium(C or D) or large(E) screws. Attach brackets to screen using four  
selected screws and four square washers(F) at the top and bottom of each  
bracket. Tighten screws firmly. Do not overtighten.  
Level wall plate(1) and use wall as a template to mark four holes. Drill four 3/8”  
(10mm) dia. holes 2(50mm) deep. Insert four anchors(H) into holes and  
secure wall plate with four long bolts(G) and four washers(I).Tighten screws  
firmly. Do not overtighten.  
Square washer(F)  
2(50mm)  
F
Large hole for  
M8 screws  
A-E  
Φ3/8(10mm)  
Medium hole for  
M5 and M6 screws  
Small hole for  
M4 screws  
Concrete Wall  
H
I
G
-5-  
-4-  
 

RadioLAN Network Router RMG 515I User Guide
Radio Shack Speaker System 40 1430 User Guide
Raypak Boiler 0180B Type H User Guide
Rogue Audio Stereo Amplifier METIS Vacuum Tube Preamplifier User Guide
Samsung Automobile Accessories SC X205L User Guide
Samsung DVR SRD 1610DC User Guide
Samsung MP3 Player YP 60V User Guide
Schumacher Automobile Battery Charger SC 600A User Guide
Schumacher Power Supply IP 125 User Guide
Scotsman Ice Ice Maker CS0415 User Guide