PYLE Audio Car Stereo System PLVW1345R User Manual

1
 
1. INSTALLATION GUIDE  
1. On a towel or soft cloth, gently place the monitor unit "facedown" on a  
stable work surface.  
2. Locate the pigtail with the DIN connector.  
3. Connect the DIN connector to the interface cable provided.  
4. Connect the RED wire to the positive (+) battery terminal.  
5. Connect the Black wire to a chassis electrical ground point.  
6. Connect the cable with YELLOW RCA jack to Video Input sources for  
your Video Program material.  
7. Connect the cable with RED and WHITE RCA jack to Audio sources for  
your Audio Program material.  
3
 
2. FUNCTION KEYS  
2.1 FUNCTIONS OF FRONT PANEL  
POWER: 1. Press the "POWER" button once; it will be "POWER ON."  
Press it again; it will be "POWER OFF."  
MENU: 1. Pop up the OSD menus. Press the "Menu" button again to  
enter the OSD menus. When in sub-menu, press.  
"EXIT" to go back to the main menu.  
UP/DN: 1. Press the "UP/DOWN" key to increase or decrease value  
2. Make item selection in OSD menus to increase or decrease  
parameters as well..  
2.2 FUNCTIONS OF REMOTE CONTROL  
4
 
Brightness:  
Contrast:  
Display adjust:  
OSD display:  
Input select:  
Audio:  
Brightness adjustment  
Contrast adjustment  
Sharpness hue, saturation adjustment  
OSD adjustment and display methods  
Switch the source of signal AV1 and AV2 Inputs.  
Only control Mute  
Recall:  
Return to the initiatives  
Exit:  
Exit  
Press "Menu key", it will display a crosswise bar with digits. To use U/D key  
to adjust value and press "Menu key" to confirm the adjustment and then the  
crosswise bar and digits will disappear, or press "Exit" to leave OSD function  
directly.  
3. TROUBLE SHOOTING  
5
 
3.1 NO POWER  
1. Make sure the power cable has been pluged in.  
2. Make sure the plug has 12V~14V, may use another electrical appliance  
to test it.  
3.2 NO FUNCTION OF REMOTE CONTROL  
1. Make sure the batteries are in good condition and installed properly.  
2. Make sure the remote control is aiming at the receiver, and there are no  
obstacles in between.  
3. Perhaps, it is too far away from the receiver. Normal distance is within 7  
meters.  
3.2 NO DISPLAY OR NOT CLEAR  
1. Check the video signal wires if they are connected properly.  
2. Check the antenna or adjust it.  
3. Make sure the TV/Video being in proper position.  
4. ACCESSORIES  
PS2/CAR CABLE  
INSTALLATION BRACKET  
USER MANUAL  
SCREW PACK  
REMOTE CONTROL  
5. SPECIFICATIONS  
6
 
ITEM  
LCD Panel  
DESCRIPTION  
13.3" TFT  
Active Area:  
Resolution:  
270.3 (W) x 202.8 (H) mm  
1024(H) x 3(RGB) x 768(V)  
262,144 colors  
0.264 (H) x 0.264 (V) mm  
CCFL Side-light type (single lamp)  
200 : 1  
Display Colors:  
Pixel Pitch (mm):  
Backlight Unit:  
Contrast Ratio:  
Brightness (cd/m2):  
Viewing Angle:  
180  
Horizontal:60O (typ.,Lift side), 60O (typ.,right  
side)  
Vertical: 30O (typ.,up side), 45O (typ.,down side)  
DC12V + 10% less than 1.3A  
Yes  
Power Supply:  
IR Transmitter:  
Power management:  
15W power consumption (typ.), less than 3W  
when in backlight sleep mode.  
Power on/off, OSD control  
1. Auto detection between NTSC/PAL  
2. Sceam is available  
User's Control:  
System:  
Dimensional Outline (mm): 329.0mm (W) x 360mm (H) x 42mm (D)  
Weight  
2.6 kg  
Safety Certifications:  
UL, FCC, CE, TUV  
Operation Temp.:0~50 degree C  
Storage Temp.: -20~60 degree C  
Humidity: 10~90%  
Environmental Condition:  
* Recommend for use with PYLE'S PLVWH1 wireless headphones.  
7
 

Peavey Stereo Equalizer PV 215 EQ User Manual
Pelco Crib Toy C1459M B 2 03 User Manual
Philips Flat Panel Television PFL5XX7H 12 User Manual
Philips Garage Door Opener 32PF9631D 10 User Manual
Philips MP3 Player 10FF2CMI User Manual
Philips Portable DVD Player AZ6880 17 User Manual
Philips Stereo Amplifier SA741C User Manual
Philips VCR VR400 User Manual
Polaroid Digital Camera t830 User Manual
PYLE Audio Car Video System PLD139 User Manual